Winterize a Saltwater Pool – How To Guide
After enjoying your saltwater pool all summer. Now it’s time to winterize your saltwater pool and get ready for next season. Here are the steps you need to take during the closing process to avoid growth of algae, staining and costly damage to the pool:
1). Avoid adding salt to winterize a saltwater pool
Salt is the key ingredient in how a swimming pool functions, and maintaining salt levels is very important. If you’re about to close your pool for the winter, or you want to know how much salt is needed. Only add salt when your water reaches 80 degrees Fahrenheit. If you add it before that, it won’t dissolve completely and could leave noticeable white spots around your pool.
2). Balance PH. levels
Saltwater is more likely to form scum on pool surfaces if the pH, alkalinity, and calcium levels are high. Wrong water PH can also hinder the efficiency of your winter chemicals, calling for the need to winterize the saltwater pool.
If the calcium level is higher than 400 ppm, keep raising it until it reaches this mark by adjusting your salt levels or adding a calcium chloride solution. Once you reach this level, remember that you will need lower total alkalinity as well.
3). Keep it clean
Before closing it, keep your pool as clean as possible. Any foreign matter left behind over the winter can stain the pool. You can brush, skim and vacuum it to clean thoroughly.
For the skimmer basket, remove any leaves and debris from the inside. Before closing the pool, filter all the water for 24 hours. Besides, ensure no chemicals are added and that you remove all traces of contaminants from your water.
Even though the pool is closed, there are still a few maintenance tips for keeping up with it through the winter. These will help during spring opening and a lower risk of damage to your pool and cover. It’s always a good idea to keep leaves and other debris off of your pool cover at all times. For the best salt for your pool, contact us today.